License Plate Lamp: Service and Repair
LICENSE LAMP REPLACEMENTREMOVAL PROCEDURE
1. Remove the license lamp screws from the rear bumper fascia.
2. Lower the license lamp down from the rear bumper fascia.
3. Rotate the license lamp socket counterclockwise to release from the license lamp housing.
4. Remove the license lamp bulb from the socket, if replacing the bulb.
INSTALLATION PROCEDURE
1. Install the license lamp bulb to the license lamp socket, if removed.
2. Install the license lamp socket to the license lamp housing, then rotate clockwise to secure.
3. Position the license lamp to the rear bumper fascia.
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the license lamp screws to the license lamp.
Tighten
Tighten the license lamp screws to 2 N.m (18 lb in).