Rear Suspension

Wheel Bearing/Hub Replacement- Rear


Removal Procedure
The wheel bearing in the rear wheel hub is integrated into one unit. Therefore, the hub is non-serviceable. If the hub and/or bearing is damaged, replace the complete hub and bearing assembly.





1. Raise and support the vehicle.
2. Remove the tire and wheel assembly.
3. Remove the rear caliper and bracket.
4. Remove the brake rotor.
5. Remove the ABS electrical connector from the wheel speed sensor (1).





6. Remove the rear wheel hub-to-knuckle bolts.
7. Remove the rear wheel hub and park brake assembly from the knuckle.





8. Remove the park brake lever bracket (8).
9. Remove the park brake actuator (6).

Installation Procedure





1. Install the park brake actuator (6).
2. Install the park brake lever bracket (8).





3. Install the rear wheel hub and park brake assembly to the knuckle.

Notice: Refer to Fastener Notice in Service Precautions.

4. Install new rear wheel hub-to-knuckle bolts.
Tighten the hub mounting bolts to 75 Nm (55 ft. lbs.).





5. Install the ABS electrical connector to the wheel speed sensor (1).
6. Install The rear brake rotor.
7. Install the rear brake caliper and bracket.
8. Install the tire and wheel assembly.
9. Lower the vehicle.