Fuel Tank Pressure Sensor: Service and Repair

FUEL TANK PRESSURE SENSOR REPLACEMENT

REMOVAL PROCEDURE

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.




1. Disconnect the negative battery cable.
2. Remove the spare tire cover, the jack and the spare tire.
3. Remove the rear compartment trim panel.
4. Remove the retaining nuts from the fuel sender access panel.
5. Remove the fuel sender access panel.




6. Disconnect the electrical connector from the fuel tank pressure sensor.
7. Remove the fuel tank pressure sensor (7) from modular fuel sender assembly.

INSTALLATION PROCEDURE




1. Install the new fuel tank pressure sensor (7) to modular fuel sender.
2. Connect the electrical connector to fuel tank pressure sensor




3. Install the fuel sender access panel.

NOTE: Refer to Fastener Notice in Service Precautions.

4. Install the fuel sender access panel retaining nuts.

Tighten
Tighten the fuel sender access panel nuts to 10 N.m (8 lb ft).

5. Install the rear compartment trim panel.
6. Install the spare tire, the jack and the spare tire cover.
7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.