Ignition Lock Cylinder
Ignition Lock Cylinder Replacement - On VehicleRemoval Procedure
1. Disconnect the negative battery cable from the battery.
2. Remove the upper and lower steering column trim covers.
3. Put the key in the steering column lock cylinder set (1).
4. Turn the key to the START position.
5. Install a 1/16 allen wrench (2) into the hole on top of the lock module assembly to release the steering column lock cylinder set retaining pin.
6. Turn the steering column lock cylinder set (1) into the RUN position.
7. Pull the steering column lock cylinder set (1) out from the lock module assembly.
8. Remove the key from the steering column lock cylinder set (1).
Installation Procedure
1. Insert the key into the steering column lock cylinder set (1).
2. Line up the locking tab (2) and the positioning tab (3) of the steering column lock cylinder set with the locking tab slot (5) and the positioning tab slot (4) in the lock module assembly (6).
3. Push the steering column lock cylinder set (1) into the lock module assembly (6).
4. Rotate the steering column lock cylinder set (1) in the lock module assembly (6) into all positions.
5. Install the upper and lower steering column trim covers.
6. Connect the negative battery cable to the battery.