Rear Door

REMOVAL PROCEDURE
The rear door stationary window is part of the door window weatherstrip. If the stationary window needs service, replace the entire door window weatherstrip.




1. Place the rear door window in the full down position.
2. Remove the rear door trim panel.
3. Remove the rear door water deflector.
4. Remove the rear door inner energy absorber pad.
5. Remove the rear door inner sealing strip.
6. Remove the rear door stationary window molding.
7. Remove the bolts from the rear door window weatherstrip.




8. Remove the rear door window weatherstrip from the rear door.

INSTALLATION PROCEDURE




1. Position the rear door window weatherstrip to the rear door starting in the corner. Work in both directions.

NOTE: Refer to Fastener Notice in Service Precautions.




2. Install the bolts to the window weatherstrip.

Tighten
Tighten the rear door window weatherstrip bolts to 10 N.m (89 lb in).

3. Close the rear door window.
4. Inspect the rear door window in order to ensure the window is properly positioned in the rear door window weatherstrip.
5. Install the rear door stationary window molding.
6. Install the rear door inner sealing strip.
7. Install the rear door inner energy absorber pad.
8. Install the rear door water deflector.
9. Install the rear door trim panel.