Standard Models (Non-Alternative Fuels)
CIRCUIT DESCRIPTIONThe Intake Air Temperature (IAT) sensor is a thermistor. The Powertrain Control Module (PCM) supplies the IAT sensor a reference voltage on the IAT sensor signal circuit and a ground circuit. When the IAT sensor is cold, the resistance is high. The IAT sensor signal voltage remains near the supplied voltage and decreases the signal voltage as the sensor warms. The control module monitors the IAT sensor signal circuit in order to calculate the temperature of the air entering the engine.
This Diagnostic Trouble Code (DTC) is designed to detect an IAT sensor signal voltage lower than possible in a normally operating IAT system.
CONDITIONS FOR RUNNING THE DTC
^ DTCs P0117, P0118, P0125, P0502, or P0503 are not set.
^ The engine run time is more than 320 seconds.
^ The vehicle speed sensor indicates that vehicle speed is more than 24 km/h (15 mph).
CONDITIONS FOR SETTING THE DTC
The IAT sensor signal voltage indicates that the intake air temperature is more than 128°C (262°F) for 3.125 seconds.
ACTION TAKEN WHEN THE DTC SETS
^ The control module illuminates the Malfunction Indicator Lamp (MIL) on the second consecutive ignition cycle that the diagnostic runs and fails.
^ The control module records the operating conditions at the time the diagnostic fails. The first time the diagnostic fails, the control module stores this information in the Failure Records. If the diagnostic reports a failure on the second consecutive ignition cycle, the control module records the operating conditions at the time of the failure. The control module writes the operating conditions to the Freeze Frame and updates the Failure Records.
CONDITIONS FOR CLEARING THE MIL/DTC
^ The control module turns OFF the Malfunction Indicator Lamp (MIL) after 3 consecutive ignition cycles that the diagnostic runs and does not fail.
^ A current DTC, Last Test Failed, clears when the diagnostic runs and passes.
^ A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other emission related diagnostic.
^ Use a scan tool in order to clear the MIL and the DTC.
DIAGNOSTIC AIDS
^ When the vehicle is at ambient temperature, compare the IAT sensor to the Engine Coolant Temperature (ECT) sensor. The IAT sensor and the ECT sensor should be relatively close to each other.
^ Use the Temperature vs Resistance Values Table below to evaluate the possibility of a skewed sensor. Refer to Temperature vs Resistance.
TEST
