Standard Models (Non-Alternative Fuels)
CIRCUIT DESCRIPTIONThe Crankshaft Position (CKP) sensor signal indicates the crankshaft speed and position. The CKP sensor is connected directly to the Ignition Control (IC) module. The circuits between the CKP sensor and the IC module consist of the following circuits:
^ The CKP sensor 1 signal circuit
^ The low reference circuit
CONDITIONS FOR RUNNING THE DTC
^ DTC P0341 is not set.
^ The engine is running.
CONDITIONS FOR SETTING THE DTC
The CKP resync counter goes more than 15 times within 4 minutes and 15 seconds.
ACTION TAKEN WHEN THE DTC SETS
^ The control module illuminates the Malfunction Indicator Lamp (MIL) on the second consecutive ignition cycle that the diagnostic runs and fails.
^ The control module records the operating conditions at the time the diagnostic fails. The first time the diagnostic fails, the control module stores this information in the Failure Records. If the diagnostic reports a failure on the second consecutive ignition cycle, the control module records the operating conditions at the time of the failure. The control module writes the operating conditions to the Freeze Frame and updates the Failure Records.
CONDITIONS FOR CLEARING THE MIL/DTC
^ The control module turns OFF the Malfunction Indicator Lamp (MIL) after 3 consecutive ignition cycles that the diagnostic runs and does not fail.
^ A current DTC, Last Test Failed, clears when the diagnostic runs and passes.
^ A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other emission related diagnostic.
^ Use a scan tool in order to clear the MIL and the DTC.
DIAGNOSTIC AIDS
^ If the complaint was Engine Cranks But Will Not Run, you may set DTC P0336 when attempting to start the engine more than 15 times and the ignition is not turned OFF between attempts.
^ An intermittent problem may be caused by the following conditions:
- Rubbed-through wire insulation
- Poor electrical connections
- Broken wire inside the insulation
^ Thoroughly check any suspected circuitry for the following conditions:
- Backed-out terminals
- Improper mating
- Broken locks
- Improperly formed terminals
- Damaged terminals
- Poor terminal-to-wire connections
- Physical damage to the wiring harness
^ An intermittent can also be the result of a defective reluctor wheel. Remove the crankshaft sensor and inspect the reluctor wheel through the hole. Refer to Crankshaft Position (CKP) Sensor Replacement.
TEST DESCRIPTION
Steps 1-10:
Steps 11-14:
The numbers below refer to the step numbers on the diagnostic table.
4. When a Medium Resolution Resync occurs, an engine stumble should also occur. If the electrical connection of a component or an electrical wire is malfunctioning, an engine stumble or a medium resolution resync may be induced by wiggling the circuit or electrical connector.
5. Operating malfunctioning non-engine related electronic components may emit Electro Magnetic Interference (EMI), which may cause a resync. This step determines if the medium resolution resyncs are being caused by an outside source.
6. Thoroughly check any suspected circuitry. Refer to Diagnostic Aids.
8. An intermittent problem may be caused by a number of conditions. Refer to Diagnostic Aids.