Arming the CTD System

Use the following procedure in order to arm the system:
1. Place the shift lever in P (park).
2. Turn OFF the ignition.
3. Open any door.

IMPORTANT: The system is not armed if the doors are locked manually, the power door lock switch or remote keyless entry transmitter must be used to arm the CTD system.
The CTD system will not arm from the power door lock switch if all doors are closed.

4. Lock the doors with the power door lock switch or the LOCK button on the transmitter. The system is in arm pending mode and will not start the arming timer until all doors are closed. The security indicator will flash indicating arm pending mode. The CTD system will arm after the last door is closed.
5. The system will arm approximately 30 seconds from the time that the last door is closed. This delay is shown by the SECURITY indicator ON STEADY. When the indicator transitions to OFF, the system is armed.