Rubber Conduit Replacement - Front Door

REMOVAL PROCEDURE




1. Remove the front door trim panel upper extension.
2. Remove the front door trim panel.
3. Remove the front door water deflector as required.
4. Mark and remove the wires from the power door lock switch, if equipped.
5. Mark and remove the wires from the door lock (5).
6. Disconnect the electrical connector for the power window regulator, if equipped.
7. Disconnect the electrical connector for the power rear view mirror, if equipped.
8. Disconnect the electrical connector for the radio speaker.
9. Using a flat-bladed tool, remove the door rubber conduit from where it attaches at the windshield pillar.
10. Using a flat-bladed tool, remove the door rubber conduit from where it attaches to the door.
11. Disconnect the harness electrical connectors (2) from the front door.
12. Remove the front door wiring harness out from the door.
13. Remove the conduit from the harness.

INSTALLATION PROCEDURE




1. Pull the wiring harness to the front door through the rubber conduit.
2. Install the rubber conduit to the front door.
3. Install the rubber conduit to the windshield pillar.
4. Connect the front door wiring harness connectors (2) to the door.
5. Install the wires to the power door lock switch, if equipped.
6. Install the wires to the door lock.
7. Connect the electrical connector for the power window regulator, if equipped.
8. Connect the electrical connector to the power rear view mirror, if equipped.
9. Connect the electrical connector to the radio speaker.
10. Install the front door water deflector as required.
11. Install the front door trim panel.
12. Install the front door trim panel upper extension.