55. Engine Front Cover Installation

Engine Front Cover Installation (JCar)

1. Install the engine front cover to the engine block.
2. Ensure that the engine front cover gasket is properly installed in the groove in the engine front cover.
3. Install the engine front cover by hand and engage it fully on the alignment dowel pins.

Notice: Refer to Fastener Notice in Service Precautions.





4. Install the engine front cover bolts.
Tighten the engine front cover bolts to 11 Nm (97 inch lbs.).





5. Install the accessory drive belt tensioner and bolt.
Tighten the accessory drive belt tensioner bolt to 50 Nm (37 ft. lbs.).