Parking Lamp: Service and Repair

PARK/[1][2]TURN SIGNAL LAMP REPLACEMENT

REMOVAL PROCEDURE




1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the bulb/socket from the park and turn lamp.
3. Remove the bulb from the socket.
4. Remove the nuts (2) from the park turn lamp.
5. Remove the park turn lamp (1) from the front bumper fascia.

INSTALLATION PROCEDURE




1. Install the park turn lamp (1) to the front bumper fascia.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the nuts (2) to the park turn lamp.

Tighten
Tighten the park turn lamp nuts to 2 N.m (18 lb in).

3. Install the bulb to the socket.
4. Install the bulb/socket to the park and turn lamp.
5. Lower the vehicle.