Gas Mass SEN/Mixture CTRL Valve to Gas Distribution Adapter

REMOVAL PROCEDURE




1. Loosen the gas distribution adapter (GDA) clamp at the throttle body.
2. Loosen the hose clamps (9) at the gas mass sensor/mixture control valve (GMS/MCV) and the GDA.
3. Loosen the clamp at the intake duct and disconnect the duct.
4. Disconnect the PCV hose.
5. Remove the GDA bracket-to-module bracket bolts.
6. Remove the GDA bracket and the GMS/MCV-to-GDA hose (9).
7. Remove the GMS/MCV-to-GDA hose clamp and the hose (9).

INSTALLATION PROCEDURE

NOTE: Refer to Fastener Notice in Service Precautions.




1. Install the GMS/MCV-to-GDA hose and the hose clamp to the GDA.

Tighten
Tighten the hose clamp to 2 N.m (18 lb in).

2. Install the GDA bracket and connect the hose (9) to the GMS/MCV.

Tighten
Tighten the hose clamp to 2 N.m (18 lb in).

3. Install the GDA bracket bolts.

Tighten
Tighten the GDA bracket bolts to 12 N.m (106 lb in).

4. Connect the PCV hose.
5. Connect the intake duct.

Tighten
Tighten the intake duct clamps to 5 N.m (44 lb in).

6. Tighten the GDA clamp at the throttle body.

Tighten
Tighten the throttle body clamp to 5 N.m (44 lb in).