Inflatable Restraint Steering Wheel Module Replacement

REMOVAL PROCEDURE




1. Disable the SIR system.
2. Use a Torx(R) driver in order to remove the bolts from the back of the steering wheel.
3. Remove the driver inflator module (1) from the steering wheel.
4. Remove the connector position assurance (CPA) (3) from the driver inflator module electrical connector.
5. Disconnect the electrical connector from the back of the driver inflator module and all other electrical connectors (2).
6. Disconnect the horn ground lead from the steering wheel.
7. Rotate the horn contact lead counterclockwise 1/4 turn in order to remove the horn contact lead from the steering column cam tower.

INSTALLATION PROCEDURE




1. Rotate the horn contact lead 1/4 turn clockwise in order to install the horn contact lead to the steering column cam tower.
2. Connect the horn ground lead to the steering wheel.
3. Connect the electrical connector to the back of the driver inflator module and all other electrical connector (2).
4. Install the CPA (3) to the driver inflator module electrical connector.
5. Install the driver inflator module (1) to the steering wheel.

NOTE: Refer to Fastener Notice in Service Precautions.

6. Use a Torx(R) driver in order to secure the module to the back of the steering wheel.

Tighten
Tighten the bolts to 10 N.m (89 lb in).

7. Enable the SIR system.