Steering Column Accident Damage Inspection - Standard Column - Off Vehicle

INSPECTION PROCEDURE





- Vehicles involved in accidents resulting in frame damage, major body or sheet metal damage, or where the steering column has been impacted, or where supplemental inflatable restraint systems deployed may also have a damaged or misaligned steering column.
- Check the capsules on the steering column bracket assembly: all must be securely seated in the bracket slots and checked for any loose conditions when pushed or pulled by hand. If not, the bracket should be replaced if bolted to the jacket assembly. If the bracket is welded to the jacket assembly replace the jacket assembly.





- Check for jacket assembly collapse by measuring the distance from the lower edge of the upper jacket to a defined point on the lower jacket. If measured dimensions are not within specifications, a new jacket must be installed.





- Visually inspect steering shaft for sheared injected plastic. If steering shaft shows sheared plastic (1), a new steering shaft must be installed.
- Any frame damage that could cause a bent steering shaft must have the steering shaft run out checked in the following manner. Using a dial indicator at the lower end of the steering shaft, have the steering wheel rotated. Run out must not exceed 1.60 MM.