122. Low/Reverse Pipe, Weir and Retainers Assemble

1. Inspect the low and reverse fluid pipe (139) for the following:
- Dents or pinches
- A plugged passage

2. Inspect the seal backup washer (144) for nicks or damage.





3. Install the backup washer (144) and a new seal (145) onto the low and reverse pipe (139).
4. Install the pipe into the case.
5. Install the pipe retainer (143) and the bolt (142) into the case.
- Tighten the bolt to 24 Nm (18 ft. lbs.).





6. Install the parking lock bracket (710) and finger start one bolt (712).
7. Install the dip stick stop and filter bracket (711) and finger start the other bolt (712).
- Tighten the two bolts to 24 Nm (18 ft. lbs.).





8. Inspect the oil weir (147) for cracks or bends.
9. Inspect the oil weir retainer (146) and the governor oil pipe retainer (143) for damage.





10. Install the oil weir (147) into the case.
11. Install the governor oil pipe retainer (143), the oil weir retainer (146), and the bolt (142).
- Tighten the bolt to 24 Nm (18 ft. lbs.).