Wiper Motor Replacement

TOOLS REQUIRED
^ J 39232 Wiper Transmission Separator
^ J 39529 Wiper Transmission Installer

REMOVAL PROCEDURE




1. Remove the wiper arms.
2. Remove the plenum chamber water deflector. Refer to Air Inlet Grille Panel Replacement in Body Front End.
3. Remove the electrical connector from the wiper motor.
4. Remove the screws and the wiper drive system module from the vehicle.




5. Remove the wiper transmission from the wiper motor crank arm using the J 39232.




6. Remove the screws and the wiper motor from the tube frame.

INSTALLATION PROCEDURE

NOTE: Refer to Fastener Notice in Service Precautions.




1. Install the wiper motor onto the tube frame with the screws.

Tighten
Tighten the wiper motor screws to 10 N.m (88 lb in).




2. Install the wiper transmission onto the wiper motor crank arm using the J 39529.




3. Install the wiper drive system module onto the vehicle with the screws.

Tighten
Tighten the wiper drive system module screws to 10 N.m (88 lb in).

4. Connect the electrical connector onto the wiper motor.
5. Install the plenum chamber water deflector. Refer to Air Inlet Grille Panel Replacement in Body Front End.
6. Install the wiper arms.
7. Operate the wipers and check for proper operation.