83. Cylinder Head Installation - Left

Cylinder Head Installation - Left

^ Tools Required
- J 36660-A Torque Angle Meter

1. Install the cylinder head gasket. Ensure the arrows point towards the front of the engine. The left cylinder head gasket has the letter L stamped next to the arrow.

Notice: Refer to Fastener Notice and Special Fastener Notice in Service Precautions.





2. Install the cylinder head.

Notice: Refer to Fastener Notice in Service Precaution.





3. Install new cylinder head bolts.
Tighten the cylinder head bolts to 50 Nm (37 ft. lbs.) in sequence. Using J 36660-A rotate each cylinder head bolt an additional 120 degrees.