Closeout/Insulator Panel Replacement - Right

Closeout/Insulator Panel Replacement - Right

Removal Procedure




1. Remove the fasteners at the rear edge of the insulators in order to disengage from the lower instrument panel.
2. Pry out the retainers in order to release.
3. Turn the heater temperature sensor 1/4 turn in order to release and allow to remain connected to its wire (CJ2 vehicles only).




4. Disconnect the electrical connectors.
5. Slide the insulator rearward in order to remove.

Installation Procedure




1. Set the forward edge of the insulator onto the shelf of the dash mat.
2. Install the heater temperature sensor (CJ2 vehicles only).
3. Connect the electrical connector.




4. Align the insulator to the floor duct at the heating, ventilating and air conditioning module.
5. Align the snap tab fasteners to the lower instrument panel and push upward in order to engage.

Notice: Refer to Fastener Notice in Service Precautions.

6. Install the fasteners.

Tighten the fasteners to 2 N.m (18 lb in).