Service Programming Methods

The 4 methods of programming a control module and the proper tools for each method are as follows:
^ Remote Programming:
- The Tech 2 or other scan tool, Techline Terminal or a personal computer equipped with General Motors Corporation authorized programming software-The Tech 2 or other scan tool is used as an interface between the vehicle and the Techline Terminal or a personal computer.
- The control module is installed in the vehicle
^ Pass Thru Programming:
- The Tech 2 or other scan tool, Techline Terminal or a personal computer equipped with General Motors Corporation authorized programming software-The Tech 2 or other scan tool is used as an interface between the vehicle and the Techline Terminal or a personal computer.
- The control module is installed in the vehicle.
^ Off-Board Remote Programming, vehicle NOT available:
- The Tech 2 or other scan tool, Off-Board Programming Adapter (OBPA), Techline Terminal or a personal computer equipped with General Motors Corporation authorized programming software-The Tech 2 or other scan tool is used as an interface between the vehicle and the Techline Terminal or a personal computer.
- The control module is NOT installed in a vehicle
^ Off-Board Pass Thru Programming
- The Tech 2 or other scan tool, off-board programming adapter (OBPA), Techline Terminal or a personal computer equipped with General Motors Corporation authorized programming software-The Tech 2 or other scan tool is used as an interface between the vehicle and the Techline Terminal or a personal computer.
- The control module is NOT installed in a vehicle