Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring

Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement - On Vehicle

^ Tools Required
- J 23653-SIR Lock Plate Compressor

Removal Procedure

Caution: Refer to SIR Caution in Service Precaution.

1. Disable the SIR system.
2. Remove the knee bolster
3. Remove the steering wheel.
4. Remove the inflatable restraint steering wheel module coil.
5. Remove the steering column trim covers.





6. Using J23653-SIR remove the bearing retainer.





7. Remove the shaft lock shield assembly (1).
8. Remove the turn signal cancel cam assembly (2).
9. Remove the upper bearing spring (3).

Installation Procedure





1. Install the upper bearing spring (3).
2. Install the turn signal cancel cam assembly (2).
3. Install the shaft lock shield assembly (1).
4. Install the bearing retainer.





5. Using J 23653-SIR depress the shaft lock shield assembly.
6. Push the bearing retainer into place.
7. Remove the J 23653-SIR from the steering shaft.
8. Install the steering column trim covers.
9. Install the inflatable restraint steering wheel module coil.
10. Install the steering wheel.
11. Install the knee bolster.
12. Enable the SIR system.