Tilt Head Housing - Assemble

Steering Column Tilt Head Housing - Assemble - Off Vehicle

^ Tools Required
- J 23653-SIR Steering Column Lock Plate Compressor
- J 42137 Steering Column Lock Plate Compressor Adapter





1. Install the inner race (5).
2. Install the upper bearing inner race seat (4).
3. Install the upper bearing spring (3).
4. Lubricate the turn signal cancel cam assembly (2).

Important: The electrical contact of the turn signal and multifunction switch assembly must rest on the turn signal cancel cam assembly.

5. Install the turn signal cancel cam assembly (2).
6. Install the cam orientation plate (1).





7. Install the new bearing retainer using J 23653-SIR.
8. Remove J 23653-SIR from the steering shaft assembly.
9. Install the inflatable restraint steering wheel module coil.
10. Enable the inflatable restraint steering wheel module.