SIR Steering Wheel Module Coil - Assemble

Inflatable Restraint Steering Wheel Module Coil - Assemble - Off Vehicle





1. Install the wave washer (1).

Caution: Refer to SIR Inflator Module Coil Caution in Service Precaution.





2. Align the block tooth on the steering shaft assembly (1) to the 12 o'clock position.

Important: A new inflatable restraint steering wheel module coil is pre-centered. Do not remove the centering tab from the new inflatable restraint steering wheel module coil until the installation is complete.

3. If installing the existing inflatable restraint steering wheel module coil, it must be centered first.





4. Align the inflatable restraint steering wheel module coil (2) with the horn tower sticking through the cam orientation plate (1).
5. Slide the inflatable restraint steering wheel module coil (2) onto the steering shaft assembly.
6. Remove and discard the centering tab from the new inflatable restraint steering wheel module coil (1).

Important: The retaining ring (1) must seat securely on the groove of the race and upper shaft assembly (2).





7. Install the retaining ring (1) using snap ring pliers.





8. Install the black inflatable restraint steering wheel module coil connector to the fused jumper assembly connector.

Caution: Refer to SIR Inflator Module Coil Caution in Service Precaution.

9. Install the wire harness straps.





10. Install the wire harness assembly into the wire restraint clip (1).
11. Install the upper and lower trim covers.
12. Enable the inflatable restraint steering wheel module.