Turn Signal Switch Housing - Assemble

Turn Signal Switch Housing - Assemble - Off Vehicle

Important: The switch mounting bracket must be pressed firmly against the steering column tilt head in order for the screws from the turn signal and multifuntion switch assembly screws to line up.





1. Slide the turn signal switch housing onto the steering column shaft assembly.

Caution: Refer to SIR Inflator Module Coil Caution in Service Precaution.

2. Install the windshield wiper and washer switch, if needed.
3. Install the turn signal and multifunction switch assembly only.
4. Install the steering column tilt head components.
5. Enable the inflatable restraint steering wheel module.