94. Crankshaft Balancer Installation

Crankshaft Balancer Installation

^ Tools Required
- J 37096 Flywheel Holding Tool
- J 36660-A Torque Angle Meter

1. Lubricate the seal surface of the crankshaft balancer with engine oil.
2. Install the crankshaft balancer.





3. Use J 37096 to hold the flywheel.

Notice: Refer to Fastener Notice and Special Fastener Notice in Service Precautions. Properly align the crankshaft balancer keyway with the crankshaft key before installation. Damage can occur to the crankshaft balancer, the crankshaft, or the installation tool if the components are not properly aligned.





4. Install the crankshaft balancer bolt.
Tighten the crankshaft balancer bolt to 150 Nm (111 ft. lbs.). Use J 36660-A to tighten the crankshaft balancer bolt an additional 76 degrees.