Wheel Bearing/Hub Replacement - Rear

Wheel Bearing/Hub Replacement - Rear

Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel.
3. Remove the brake rotor.





4. Remove the antilock brake electrical connector.
5. Remove the wheel bearing and hub retaining bolts from the control arm.
6. Remove the wheel bearing and hub assembly from the control arm.
7. Remove the brake shield from the control arm.
8. Clean the control arm face and the bore before installing the wheel bearing and hub assembly.

Installation Procedure

Notice: Refer to Fastener Notice in Service Precautions.





1. Install the brake shield and the wheel bearing and hub assembly to the control arm with the retaining bolts. Be careful not to drop the hub and the bearing, as it could be damaged. Reconnect the ABS sensor.
Tighten the wheel bearing and hub retaining bolts to 70 Nm (52 ft. lbs.).
2. Install the brake rotor.
3. Install the wheel and the tire.
4. Lower the vehicle.