Windshield Wiper & Washer Switch - Assemble

Windshield Wiper and Washer Switch Assembly - Assemble - Off Vehicle





1. Slide the windshield wiper and washer switch assembly into the signal switch housing so that the locking tabs snap into place.
2. Connect the windshield wiper and washer switch assembly connector.

Caution: Refer to SIR Inflator Module Coil Caution in Service Precaution.

3. Install the wire harness straps





4. Install the wire harness assembly into the wire restraint clip (1).
5. Install the upper and lower trim covers.
6. Enable the inflatable restraint steering wheel module.