Strut Replacement - Rear Lift Panel
Strut Replacement - Rear Lift Panel
Removal Procedure
Caution: When a lift gate hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.
Notice: Apply pressure only at the end of the hood assist rod that you are removing or attaching. Do NOT apply pressure to the middle of the rod because damage or bending will result.
1. Raise the rear compartment lid and support.
2. Use a flat-blade screwdriver to carefully remove the strut from the mounts.
3. Remove the rear lift panel strut (2) from both the rear trunk lid (1) and from the rear body mounts (3). Remove the strut from the vehicle.
Installation Procedure
Important: Install the strut by firmly pressing it into place on the mounts until you hear a snap. Tug on the strut to ensure that it is securely installed.
1. Install the rear lift panel strut (2) to both the rear trunk lid (1) and the rear body mounts (3).
2. Remove the support and close the rear compartment lid.