Strut Replacement - Rear Lift Window Panel

Strut Replacement - Rear Lift Window Panel

Removal Procedure

Caution: When a lift window hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.

Notice: Apply pressure only at the end of the hood assist rod that you are removing or attaching. Do NOT apply pressure to the middle of the rod because damage or bending will result.

1. Raise the rear liftgate and support.




2. Remove the bolt (4) from the rear liftgate strut rod (3) and from the body.
3. Use a flat-bladed tool to remove the strut from the mounts.
4. Remove the rear lift panel strut (2) from the rear trunk lid mount (1) and remove the strut from the vehicle.

Installation Procedure






Important: Install the strut by firmly pressing into place on mounts until you hear a snap. Tug on the strut to ensure that the unit is securely installed.

1. Install the rear lift panel strut (2) to the rear trunk lid mount (1).

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the bolt (4) to rear liftgate strut rod (3) and body.

Tighten the bolt to 27 N.m (20 lb ft).

3. Remove the support and close the liftgate.