Fog Lamp Replacement - Front (Trans Am)

REMOVAL PROCEDURE

CAUTION: Refer to Halogen Bulb Caution in Service Precautions.




1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the push pin retainers that are located at the bottom center of the front fascia.
3. Disconnect the electrical connector from the fog lamp.




4. Remove the fog lamp bolts.
5. Remove the fog lamp and bracket from the vehicle.

INSTALLATION PROCEDURE




1. Position the fog lamp and bracket to the vehicle.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the fog lamp bolts.

Tighten
Tighten the fog lamp bolt to 15 N.m (11 lb ft).




3. Connect the electrical connector to the fog lamp.
4. Install the push pin retainers at the bottom center of the front fascia.
5. Lower the vehicle.