European Low Beam (Right Hand Rule of Road) (Export Only)

Check the following for the European low beam headlamps.

IMPORTANT: DO NOT cover the headlamp, this may cause excessive heat build up.




1. Turn on the low beam headlamps and block the light from projecting onto the screen from the passenger side headlamp.
2. To adjust the headlamp aim perform the following:
^ For the horizontal aim set the center beam's break point (3) should be on the vertical axis (1), or within -38.1 mm (-1.5 in) (5) or 38.1 mm (1.5 in) (4) of the vertical axis (1).
^ For the vertical aim set the beam's break point (3) at -92.25 mm (-3.75 in) (7) below the horizontal axis (2), or within -57.15 mm (-2.25 in) (8) or -171.45 mm (-6.75 in) (6) below the horizontal axis (2).
3. If the above specifications are not met adjust the headlamps accordingly.
4. Repeat the aiming procedure for the passenger side headlamp while blocking the light from projecting onto the screen from the driver side headlamp.