Removal and Replacement

REMOVAL PROCEDURE

CAUTION: Refer to Halogen Bulb Caution in Service Precautions.




1. Turn the ignition key to the RUN position (4).
2. Turn the headlamps ON, then turn the switch back to park lamps.
This will leave the headlamps in the up position with the lamps off.
3. Turn the ignition key to the OFF position (1).




4. Open the hood.
5. Remove the headlamp bezel screws.
6. Remove the headlamp bezel.




7. Remove the headlamp mounting ring screws from the headlamp housing.
8. Remove the headlamp mounting ring.
9. Disconnect the electrical connector from the headlamp.




10. Remove the headlamp from the housing.

INSTALLATION PROCEDURE




1. Connect the electrical connector to the headlamp.
2. Position the headlamp to the housing.




3. Install the headlamp mounting ring.

NOTE: Refer to Fastener Notice in Service Precautions.

4. Install the headlamp mounting ring screws to the headlamp housing.

Tighten
Tighten the screws to 2 N.m (18 lb in).




5. Install the headlamp bezel.
6. Install the headlamp bezel screws.

Tighten
Tighten the screws to 2 N.m (18 lb in).

7. Close the hood.
8. Turn the headlamp switch off.