Turn Signal Flasher Replacement (Export)

REMOVAL PROCEDURE




1. Open the IP compartment door.
Push in on the sides of the compartment, and drop the compartment down.
2. Remove the turn signal flasher from the SIR bracket.
3. Remove the insulator tape from the flasher.
4. Disconnect the turn signal flasher electrical.

INSTALLATION PROCEDURE




1. Connect the turn signal flasher electrical connector.
2. Install the insulator tape to the flasher.
3. Install the turn signal flasher to the SIR bracket.
4. Push in on the sides of the compartment, and insert the compartment.
5. Close the IP compartment door.