Park/Turn Signal Lamp Replacement (Trans Am)

REMOVAL PROCEDURE




1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Open the access door in the front bumper air deflector.
3. Disconnect the electrical connector from the park and turn signal lamp.
4. Remove the park and turn signal lamp bolts.
5. Remove the park and turn signal lamp from the fascia.

INSTALLATION PROCEDURE




1. Position the park and turn signal lamp to the front fascia.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the park and turn signal lamp bolts.

Tighten
Tighten the park and turn signal lamp bolts to 3 N.m (27 lb in).

3. Connect the electrical connector to the park and turn signal lamp.
4. Close the access door in the front bumper air deflector.
5. Lower the vehicle.