Spark Plug Wire Replacement (Bank 1)

REMOVAL PROCEDURE




1. Disconnect the odd numbered plug wires (1, 3, 5) from the ignition coils.

NOTE: Twist the spark plug boot one-half turn in order to release the boot. Pull on the spark plug boot only. Do not pull on the spark plug wire or the wire could be damaged.

2. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.




3. Remove the plug wires from the spark plugs.
4. Remove the spark plug wire harness from the vehicle.

INSTALLATION PROCEDURE

IMPORTANT: The lower tabs of the heat shield must extend over the hex on the spark plug in order to complete installation of the heat shield and the boot on the spark plug.




1. Install the spark plug wire harness to the vehicle.
2. Install the spark plug wires to the spark plugs.
3. Lower the vehicle.




4. Connect the odd numbered plug wires (1, 3, 5) to the ignition coils.