Fastener Tightening Specifications
| A/C Compressor and Condenser at the Accumulator | 36 ft. lbs. | |
| A/C Compressor and Condenser Hose Bolt at the Compressor | 24 ft. lbs. | |
| A/C Compressor and Condenser Hose Nut | 12 ft. lbs. | |
| Auto Left Side Trans Support to Engine Bolts | 21 ft. lbs. | |
| Auto Left Side Trans Support to Transmission Bolt | 75 inch lbs. | |
| Auto Left Side Trans Support Nut | 59 ft. lbs. | |
| Auto Right Side Trans Support to Engine Bolts | 75 inch lbs. | |
| Auto Right Side Trans Support to Trans Bolt | 75 inch lbs. | |
| Battery Positive Cable Harness Nut | 18 ft. lbs. | |
| Camshaft sprocket bolt | 74 ft.lbs. + 90° | |
| Camshaft thrust Plate Bolt | 11 ft.lbs. | |
| Coolant Pump bolt | 11 ft.lbs. + 80° | |
| Coolant pump pulley bolt | 116 in.lbs. | |
| Crankshaft balancer bolt | 111 ft.lbs + 114° | |
| Crankshaft position sensor stud | 22 ft.lbs. | |
| Crankshaft rear oil seal housing bolt | 11 ft.lbs. + 50° | |
| Cylinder head bolt | 37 ft.lbs. + 120° | |
| Drive belt idler pulley bolt | 37 ft.lbs. | |
| Drive belt tensioner bolt | 37 ft.lbs. | |
| EGR valve adapter bolt | 18 ft.lbs. | |
| EGR valve adapter nut | 37 ft.lbs. | |
| EGR valve nut | 21 ft.lbs. | |
| EGR valve outlet pipe bolt/nut (except upper intake manifold) | 22 ft.lbs. | |
| Engine coolant temperature sensor | 18 ft.lbs. | |
| Engine flywheel bolt | 11 ft.lbs. + 50° | |
| Engine front cover bolt/stud | 15 ft.lbs. + 40° | |
| Engine ground strap bolt | 18 ft.lbs. | |
| Engine harness clamp bolt | 53 in.lbs. | |
| Engine lift bracket bolt/nut stud | 22 ft.lbs. | |
| Engine mount bolts | 43 ft.lbs. | |
| Engine mount bracket bolt | 75 ft.lbs. | |
| Engine mount strut bracket stud at engine, left | 64 ft.lbs. | |
| Engine mount strut bracket bolt at engine, right | 37 ft.lbs. | |
| Engine mount through bolt nut | 59 ft.lbs. | |
| Engine wiring harness ground bolt | 18 ft.lbs. | |
| EVAP canister purge valve bolts | 89 in.lbs. | |
| Flywheel housing inspection cover bolts | 80 in.lbs. | |
| Fuel pipe heat shield nut | 44 in.lbs. | |
| ICM assembly bolt | 37 ft.lbs. | |
| Lower intake manifold bolt | 11 ft.lbs. | |
| Manifold vacuum source screws | 89 in.lbs. | |
| Manual transmission to engine bolts | 70 ft.lbs. | |
| Manual transmission to support brace bolt to transmission | 37 ft.lbs. | |
| Manual transmission support brace bolts to engine | 21 ft.lbs. | |
| Oil filter adapter bolt | 22 ft.lbs. | |
| Oil level indicator tube nut | 14 ft.lbs. | |
| Oil pan drain plug | 22 ft.lbs. | |
| Oil pressure sensor | 12 ft.lbs. | |
| Oil pump cover screw | 98 in.lbs. | |
| Oil pump, pipe and screen bolt | 11 ft.lbs. | |
| Positive crankcase (PCV) valve cover bolt | 106 in.lbs. | |
| Right side transmission support nut | 59 ft.lbs. | |
| Shock absorber bolts | 48 ft.lbs. | |
| Throttle body bolt/nut | 89 in.lbs. | |
| Timing chain dampener bolt | 16 ft.lbs. | |
| Transmission oil cooler pipe bracket bolt | 13 ft.lbs. | |
| Transmission support bolts | 42 ft.lbs. | |
| Upper ball joint nuts | 39 ft.lbs. | |
| Upper intake manifold bolts (long) | 22 ft.lbs. | |
| Upper intake manifold bolts (short) | 11 ft.lbs. | |
| Valve lifter guide retainer bolt | 22 ft.lbs. | |
| Valve rocker arm bolt | 11 ft.lbs. + 90° | |
| Valve rocker arm cover bolt | 89 in.lbs. | |
| Wiring harness ground bolt to front rail | 106 in.lbs. | |
| Balance shaft driven gear bolt | First pass | 16 ft.lbs. |
| Final pass | +70° | |
| Balance shaft retainer bolt | 22 ft.lbs. | |
| Camshaft position sensor bolt | 89 in.lbs. | |
| Connecting rod bearing cap bolts | First pass | 20 ft.lbs. |
| Final pass | +50° | |
| Coolant drain plug (Block) | 13 ft.lbs. | |
| Crankshaft balancer bolt | First pass | 111 ft.lbs. |
| Final pass | +114° | |
| Crankshaft main bearing cap bolt Tighten the crankshaft main bearing cap bolts in equal increments. Do not completely tighten one bolt at a time to prevent the cap from being cocked. | First pass | 30 ft.lbs. |
| Final pass | +110° | |
| Crankshaft main bearing cap bolt (Side) | First pass | 11 ft.lbs. |
| Final pass | +45° | |
| Crankshaft rear oil seal housing bolt | First pass | 11 ft.lbs. |
| Final pass | +50° | |
| Drive belt tensioner bracket stud | 53 in.lbs. | |
| EGR valve outlet pipe bolt/nut | 21 ft.lbs. | |
| Engine lift bracket bolt (Front) | 18 ft.lbs. | |
| Engine lift bracket bolt/stud (Rear) | 22 ft.lbs. | |
| Engine oil gallery plug | 22 ft.lbs. | |
| Engine oil pressure sensor | 12 ft.lbs. | |
| Engine wiring harness bracket stud | 37 ft.lbs. | |
| Exhaust manifold bolt/nut | 17 ft.lbs. | |
| Exhaust manifold heat shield bolt | 89 in.lbs. | |
| Exhaust manifold heat shield nut | 17 ft.lbs. | |
| Exhaust manifold pipe stud | 53 in.lbs. | |
| Exhaust manifold stud | 89 in.lbs. | |
| Fuel injector rail assembly nut | 80 in.lbs. | |
| Fuel injector rail stud | 18 ft.lbs. | |
| Generator bracket bolt | 37 ft.lbs. | |
| Heated oxygen sensor | 31 ft.lbs. | |
| Ignition control module bracket bolt | 37 ft.lbs. | |
| Ignition control module assembly nut | 22 ft.lbs. | |
| Oil cooler adapter connector | 37 ft.lbs. | |
| Oil filter | 22 ft.lbs. | |
| Oil level sensor bolt | 15 ft.lbs. | |
| Oil pan bolt | 125 in.lbs. | |
| Spark plug (intial installation) | 20 ft.lbs. | |
| Spark plug (re-installation) | 11 ft.lbs. | |
| Spark plug wire retainer bracket bolt | 22 ft.lbs. | |
| Starter motor heat shield bolt | 22 ft.lbs. | |
| Vacuum source manifold bolt | 89 in.lbs. | |
| Water outlet housing bolt | 20 ft.lbs. | |
| Water pump bolt | Large bolt | 25 ft.lbs. |
| Small bolt | 16 ft.lbs. | |
| Water pump pulley bolt | 116 in.lbs. |