SIR Steering Wheel Module Coil - Assemble

Inflatable Restraint Steering Wheel Module Coil - Assemble - Off Vehicle

- Tools Required
- J 41352 Modular Column Holding Fixture

Important: If installing the existing inflatable restraint steering wheel module coil it must be centered first.
A new inflatable restraint steering wheel module coil will come pre-centered. Do not remove the orange tab from the inflatable restraint steering wheel module coil until installation is complete





1. Feed the inflatable restraint steering wheel module coil connectors through the steering column.
2. Install the inflatable restraint steering wheel module coil (4) following these steps:
2.1. Position the inflatable restraint steering wheel module coil (4) to the steering shaft assembly (2).
2.2. Align the opening in the inflatable restraint steering wheel module coil (4) with the horn tower (1).
2.3. Seat the inflatable restraint steering wheel module coil (4) onto the steering shaft assembly (2).
3. Remove and dispose of the orange tab if using a new inflatable restraint steering wheel module coil.
4. Install the retaining ring (3) to the steering shaft assembly (2).





Notice: Refer to Improper Routing of the Wire Harness Notice in Service Precautions.

Important: Pull carefully on all the wires to remove any wire kinks that may be inside the steering column assembly.

5. Install the wiring protector and the wire harness straps to the steering column.
6. Connect the inflatable restraint steering wheel module coil connector at the base of the column.





7. Install the small wire harness straps.
8. Install the wire harness assembly strap (1).
9. Remove the steering column and J 41352 from the vise.
10. Install the steering column into the vehicle.
11. Install the steering wheel onto the steering column.
12. Enable the inflatable restraint steering wheel module.