Steering Wheel

Steering Wheel Replacement

- Tools Required
- J 1859-A Steering Wheel Puller
- J 38720 Steering Wheel Puller Bolts

Removal Procedure





1. Remove the SIR module from the steering wheel.
2. Remove the steering wheel retaining nut (3)
3. Disconnect the horn ground lead (5).

Notice: When attaching J 1 859-A and J 38720 to the steering wheel, use care to prevent threading J 39720 (bolts) all the way through the steering wheel hub into the SIR coil and damaging the SIR coil.

4. Use J 1859-A and J 38720 in order to remove the steering wheel (2).
5. Remove the steering wheel horn switch.

Installation Procedure





1. Route the SIR coil electrical connector to the steering wheel (2).
2. Install the steering wheel horn switch.
3. Install the steering wheel (2).
4. Connect the horn ground lead (5).

Notice: Refer to Fastener Notice in Service Precautions.

5. Install the steering wheel retaining nut (3).
- Tighten the steering wheel retaining nut to 43 Nm (32 ft. lbs.).
6. Install the SIR module to the steering wheel.