Turn Signal & Multifunction Switch - Assemble

Turn Signal and Multifunction Switch Assembly - Assemble - Off Vehicle





1. Thread the turn signal and multifunction switch assembly connector through the lock housing cover and sleeve assembly, if the switch is hanging.





Notice: Refer to Fastener Notice in Service Precautions.

2. Install the turn signal and multifunction switch assembly and secure using 3 pan head 6 lobed socket screws (1).
- Tighten the 3 pan head 6-lobed socket screws to 3.5 Nm (31 inch lbs.).
3. Lubricate the signal switch arm assembly (3) with lithium grease.
4. Install the signal switch arm assembly (3) onto the turn signal and multifunction switch assembly.
5. Secure the signal switch arm assembly (3) using the round washer head screw (2).
- Tighten the screw to 2.5 Nm (22 inch lbs.).





6. Install the terminal connector to the turn signal and multifunction switch assembly connector.





Notice: Refer to Improper Routing of the Wire Harness Notice in Service Precautions.

Important: Pull carefully on all the wires to remove any wire kinks that may be inside the steering column assembly.

7. Pull the turn signal and multifunction switch assembly connector towards the base of the column.
8. Insert the wiring protector into the steering column bracket.
9. Insert the steering column wire harness into the steering column wire harness strap.
10. Install the turn signal cancel cam and upper bearing inner race.
11. Install the tilt lever.
12. Install the multifunction lever.
13. Install the hazard knob.