Outer

Tie Rod End Replacement - Outer

- Tools Required
- J 24319-B Universal Steering Linkage Puller

Removal Procedure





1. Raise the vehicle on a hoist. Refer to Vehicle Lifting.
2. Remove the tire and wheel.
3. Remove the cotter pin (3) and the hex slotted nut (2) from the outer tie rod (1).





4. Loosen the jam nut (2) on the inner tie rod (1).





5. Disconnect the outer tie rod from the steering knuckle using J24319-B.





6. Remove the outer tie rod (3) from the inner tie rod (1).

Installation Procedure





1. Install the outer tie rod (3) to the inner tie rod (1). Do not tighten the jam nut (2).





2. Install the outer tie rod (2) to the steering knuckle (1).

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the hex slotted nut (2) to the outer tie rod stud (1).
- Tighten the hex slotted nut (2) to 47 Nm (35 ft. lbs.). Align the cotter pin slot by tightening the hex slotted nut (2) up to 1/6 additional turn, or 70 Nm (52 ft. lbs.) maximum. Do not back off the hex slotted nut (2) for the cotter pin (3) insertion.
4. Install the cotter pin (3) into the hole in the tie rod stud.
5. Adjust the front toe.