Flywheel: Service and Repair

Engine Flywheel Replacement

^ Tools Required
- J 37096 Flywheel Holding Tool
- J 36660-A Torque Angle Meter

Removal Procedure





1. Remove the clutch, if equipped with a manual transmission.
2. Remove the automatic transmission, if equipped.
3. Use the J 37096 to hold the flywheel to loosen the flywheel bolts.





4. If equipped with the manual transmission, remove the following components:
4.1. Remove the flywheel bolts (1).
4.2. Remove the flywheel (2).





5. If equipped with the automatic transmission, remove the following components:
5.1. Remove the flywheel bolts (1).
5.2. Remove the flywheel (2).

Installation Procedure





1. If equipped with the automatic transmission, install the following components:
1.1. Install the flywheel (2).
1.2. Install the flywheel bolts (1) finger tight.





2. If equipped with the manual transmission, install the following components:
2.1. Install the flywheel (2).
2.2. Install the flywheel bolts (1) finger tight.





3. Using J 37096, hold the flywheel when tightening the flywheel bolts.

Notice: Refer to Fastener Notice in Service Precautions.

4. Tighten the flywheel bolts.
^ Tighten the flywheel bolts to 15 Nm (11 ft. lbs.). Using the J 36660-A to torque the flywheel bolts an additional 50°.
5. Install the automatic transmission, if equipped.
6. Install the clutch, if equipped with a manual transmission.