Fixed Antenna Replacement
REMOVAL PROCEDURENOTE: Refer to Antenna Mast Paint Notice in Service Precautions.
1. Unscrew the antenna mast (1) and remove from the antenna base (4).
2. Remove the quarter inner rear trim finishing panel.
3. Remove the spare tire and the jack.
4. Remove the antenna cable (3) from the antenna base (4).
5. Remove the antenna base bracket bolt (5).
6. Pull down the antenna base (4) from the antenna bezel (2). Disengage the bracket.
7. Remove the antenna base (4).
8. Unsnap the bezel (2) from the rear fender.
9. Remove the antenna bezel (2).
INSTALLATION PROCEDURE
1. Align the bezel (2) with the opening in the rear fender.
2. Install the antenna bezel (2) by pressing into the rear fender until fully seated.
3. Install the antenna base (4).
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the antenna base bracket bolt (5).
Tighten
Tighten the bolt to 5 N.m (44 lb in).
5. Install the antenna cable (3) to the antenna base (4).
6. Install the spare tire and the jack.
7. Install the quarter inner rear trim finishing panel.
8. Thread the antenna mast (1) to the antenna base (4).
Tighten
Tighten the mast to 5 N.m (44 lb in).