Remote CD Changer Replacement (Convertible)
REMOVAL PROCEDURE1. Open the trunk.
2. Remove the compact disc (CD) magazine from the CD player.
3. Remove the CD changer mounting nut.
4. Disconnect the CD changer electrical connector.
5. Remove the CD changer.
6. Remove the bolts and brackets from the CD changer, as needed.
7. If you will transport or ship the CD changer, reinstall the shipper pin. Insert the pin into the top of the changer. Use tape in order to fix the pin in place.
8. If you install a new CD changer, remove the shipper pin. Cover the hole with the supplied adhesive material.
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
1. Install the brackets and the bolts to the CD changer, as needed.
Tighten
Tighten the bolts to 1.9 N.m (17 lb in).
2. Install the CD changer.
3. Connect the CD changer electrical connector.
4. Position the inboard stud through the bracket hole.
5. Position the inboard hole over the stud.
6. Install the CD changer mounting nut.
Tighten
Tighten the nut to 2.5 N.m (22 lb in).
7. Install the CD magazine to the CD changer.
8. Close the trunk.