Radio/Stereo: Service and Repair
RADIO REPLACEMENTREMOVAL PROCEDURE
1. Unsnap the instrument panel (IP) accessory trim plate.
2. Remove the radio bracket bolts (1).
3. Slide the radio (2) out from the IP.
4. Disconnect the following components from the radio (4):
^ The IP wiring harness connector (1)
^ The remote CD connector (2)
^ The antenna cable (3)
5. Remove the radio from the vehicle.
INSTALLATION PROCEDURE
1. Install the radio (4) to the vehicle.
2. Connect the following components to the radio:
^ The antenna cable (3)
^ The remote CD connector (2)
^ The IP wiring harness connector (1)
3. Slide the radio (2) into the IP.
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the radio bracket bolts (1) in the following sequence:
4.1. Lower left
4.2. Upper right
4.3. Upper left
Tighten
Tighten the radio bracket bolts to 1.8 N.m (16 lb in).
5. Install the IP accessory trim plate.
6. Disable the radio Theftlock(R) feature. Refer to Radio/Audio System Description and Operation (Chevrolet) or Radio/Audio System Description and Operation (Pontiac).