Lumbar Switch Replacement - Front

Lumbar Switch Replacement - Front

Removal Procedure




1. Remove the front bucket seat (1).
2. Remove the recliner trim cover screws from the seat.
3. Remove the hinge arm trim cover (2) from the bucket seat (1).
4. Disconnect the wire harness from the lumbar seat switch (5).
5. While applying light pressure to the lumbar switch, use a flat-bladed tool to disengage the lock tabs on the hinge arm trim cover.
6. Remove the lumbar seat switch (5) from the recliner trim cover (2).

Installation Procedure




1. Align the lumbar seat switch (5) with the opening in the hinge arm trim cover (2).
2. Press inward on the lumbar seat switch until the switch is fully seated in the trim cover. Engage the lock tabs.
3. Connect the wire harness to the lumbar seat switch (5).
4. Install the recliner trim cover (2) to the bucket seat (1).

Notice: Refer to Fastener Notice in Service Precautions.

5. Install the recliner trim cover screws.

Tighten the screws to 1.7 N.m (15 lb in)

6. Install the bucket seat.