Seat Replacement - Front Bucket (Power)

Seat Replacement - Front Bucket (Power)

Removal Procedure

1. Place a protective tape over the nearby trim and paint.
2. Position the front power bucket seat to the full upward and midway position.




3. Remove the screws from the inner and outer front adjuster nut covers, and remove the covers.




4. Remove the screw from the rear inner adjuster nut cover, and remove the cover.




5. Remove the screw from the rear outer adjuster nut cover, position the cover to access the adjuster nut.




6. Remove the seat adjuster nuts from the studs.




7. Disconnect the seat belt wiring harness electrical connector, and the lumbar air supply hose.




8. Remove the front bucket seat from the vehicle.

Installation Procedure




1. Install the front bucket seat to the vehicle.




2. Connect the seat belt wiring harness electrical connector, and the lumbar air supply hose.






Notice: Refer to Fastener Notice in Service Precautions.

3. Install the seat adjuster nuts to the studs.

Tighten the nuts to 50 N.m (37 lb ft).




4. Install the screw to the rear outer adjuster nut cover.

Tighten the screw to 2 N.m (18 lb in).




5. Install the rear inner adjuster nut cover and install the screw to the cover.

Tighten the screw to 2 N.m (18 lb in).




6. Install the inner and outer front adjuster nut covers, and install the screws to the covers.

Tighten the screws to 2 N.m (18 lb in).

7. Position the front power bucket seat to the original setting.
8. Remove the protective tape from the nearby trim and paint.