Horn: Service and Repair
REMOVAL PROCEDURE1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the front bumper fascia air deflector.
3. Remove the horn bolt (2).
4. Remove the horns from the right engine compartment side outer rail.
5. Disconnect the horn electrical connector (1).
INSTALLATION PROCEDURE
1. Connect the horn electrical connector (1).
2. Align the horns to the rear two holes in the right engine compartment side outer rail.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the horn boll (2).
Tighten
Tighten the bolt (2) to 27 N.m (20 lb ft).
4. Install the front bumper fascia air deflector.
5. Lower the Vehicle.