License Lamp Replacement (Export)

REMOVAL PROCEDURE




1. Remove the rear license lamp screws.
2. Remove the rear license lamp from the rear fascia.




3. Disconnect the license lamp electrical connector.
4. Remove the rear license lamp bulbs (2), if necessary.

INSTALLATION PROCEDURE




1. Install the rear license lamp bulbs (2), if removed.
2. Connect the license lamp electrical connector.




3. Position the rear license lamp to the rear fascia.

NOTE: Refer to Fastener Notice in Service Precautions.

4. Install the rear license lamp screws.

Tighten
Tighten the rear license lamp screws to 2 N.m (18 lb in).