Fuel Pump Pickup Filter: Service and Repair

FUEL STRAINER REPLACEMENT

REMOVAL PROCEDURE




1. Remove the fuel sender assembly.
2. Note the position of the fuel strainer (4) on the fuel pump.
3. Support the fuel sender assembly with one hand and grasp the strainer (4) with the other hand.
4. Pull the strainer off the pump. Discard the strainer after inspection.
5. Inspect the strainer. Replace a contaminated strainer and clean the fuel tank.

INSTALLATION PROCEDURE




1. Install a new fuel strainer (4) in the same position as noted during disassembly. Push the strainer on the bottom of the fuel sender until the strainer is fully seated.
2. Install the fuel sender assembly.