P1189
CIRCUIT DESCRIPTIONThe engine oil pressure switch closes and the signal circuit is low with low oil pressure. The engine oil pressure switch opens and signal circuit is high with oil pressure above 4.5 psi. The PCM monitors the oil pressure switch signal circuit and sends a class 2 message to the Body Control Module (BCM) indicating the switch status. The BCM sends a message via the class 2 serial data circuit to the IPC in order to illuminate the low oil pressure indicator.
CONDITIONS FOR RUNNING THE DTC
^ The following DTCs are not set:
- P0117
- P0118
- P1111
- P1114
^ The ignition is ON, with the engine OFF.
^ The engine temperature is 10°C (50°F) less than the last key OFF temperature.
CONDITIONS FOR SETTING THE DTC
^ The PCM detects that the oil pressure switch signal circuit is high.
^ The above condition is present for greater than 10 seconds.
ACTION TAKEN WHEN THE DTC SETS
The PCM stores the conditions that are present when the DTC sets as Failure Records data only. This information is not stored as Freeze Frame data.
CONDITIONS FOR CLEARING THE DTC
^ The DTC becomes history when then conditions for setting the DTC are no longer present.
^ The history DTC clears after 40 malfunction free warm-up cycles.
^ The PCM receives the clear code command from the scan tool.
TEST
