Radio/Stereo: Service and Repair
RADIO REPLACEMENTREMOVAL PROCEDURE
IMPORTANT: Perform the radio set up procedure for new and reinstalled radios. Refer to Radio Setup.
1. Remove the Instrument Panel (IP) accessory trim plate.
2. Remove the radio screws.
3. Pull the radio toward you for access to the connectors.
4. Disconnect the IP wiring harness connector and the antenna cable connector from the radio.
5. Remove the radio from the IP.
INSTALLATION PROCEDURE
1. Position the radio to the Instrument Panel (IP).
2. Connect the IP wiring harness connector and the antenna cable connector to the radio.
IMPORTANT: If the radio locator tab is difficult to align to the IP locator opening, pull the radio toward you and reposition the antenna cable.
3. Align the radio locator tab to the IP locator opening. Install the radio.
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the radio screws.
Tighten
Tighten the radio screws to 2 N.m (18 lb in).
5. Install the IP accessory trim plate.
6. Perform the radio set up procedure for new and reinstalled radios. Programming and Relearning